Announcement

Collapse
No announcement yet.

Installing Via 4 in 1 drivers

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Installing Via 4 in 1 drivers

    I was using a g400 (single head 32 Mb) and it worked just fine playing almost all games.

    I just replaced the g400 with a g550 and I cant play any of my favorite games at all.

    OpenGL games simply tell me that they cant initialize an OpenGL surface and D3D games run painfully slow (less than 5 fps).

    I used the matrox uninstall utility to remove all of the old drivers first.


    Any advice would be very appreciated....

    Edit Sasq: Thread coppied from Games, posts have been deleted to save space. Original Title also changed
    Last edited by Sasq; 17 December 2001, 01:04.

  • #2
    1. Goto control panel and use the add/remove Matrox Graphics software.
    2. Reboot directly into safe mode.
    3. Go into device manager and delete all display adapters and monitors.
    4. Reboot and go in your system BIOS.
    5. Be sure that USB is enabled, PNP OS set to YES, Assign IRQ to VGA enabled and AGP aperture size set to 256 or the highest.
    6. Boot in normal mode.
    7. Upon detection of the card install drivers for standard VGA adapter from windows list only. Do not install Matrox drivers at this point.
    8. Install the latest 4 in 1 patch rev 4.33 from VIAs website www.viatech.com
    9. Reboot.
    10. Install the latest Matrox drivers
    11. reboot and configure as needed.

    You may also want to grab MTST Utility for a bit of tweaking if neccessary.

    Edit Sasq: removed older driver links
    Last edited by Sasq; 17 December 2001, 01:02.
    "Be who you are and say what you feel, because those who mind don't matter, and those who matter don't mind." -- Dr. Seuss

    "Always do good. It will gratify some and astonish the rest." ~Mark Twain

    Comment

    Working...
    X