Tweet
Hello, anybody had this problem?
G550 is connected to a monitor and to a TV via SCART-RGB cable.
dualhead, clone mode and dvdmax modes are enabled.
RGB-SCART is enabled of course.
Also I installed the latest BIOS and drivers.
The problem is: there is nothing on the TV after OS loading until I open display driver settings and select something like "Adjust TV Settings" or "Configure DVDMax" (I don't remember exact names). After that signal appears and TV shows OK, clone mode and DVDMax work just fine. Sometimes the TV signal appears if I start playing some movie and DVDMax is activated or when I enable clone mode manually via shortcut, but this happens in rare cases only.
Any idea where I should look for a problem? RGB-cable/TV/videocard/software? Did I miss something important ?
thanks
G550 is connected to a monitor and to a TV via SCART-RGB cable.
dualhead, clone mode and dvdmax modes are enabled.
RGB-SCART is enabled of course.
Also I installed the latest BIOS and drivers.
The problem is: there is nothing on the TV after OS loading until I open display driver settings and select something like "Adjust TV Settings" or "Configure DVDMax" (I don't remember exact names). After that signal appears and TV shows OK, clone mode and DVDMax work just fine. Sometimes the TV signal appears if I start playing some movie and DVDMax is activated or when I enable clone mode manually via shortcut, but this happens in rare cases only.
Any idea where I should look for a problem? RGB-cable/TV/videocard/software? Did I miss something important ?
thanks
Comment