If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Originally posted by bokuden Hello
Sorry,not working.
Invalid pins offset
and Unkwnown pins version,cannot decode.
What's this?
Best regards
It couldn't fix your pins.. you'll either have to RMA the card.
or ask someone here, or at matrox to do the following,
so you can restore your card.
go into a true dos 6.22/9X (NOT NT/2K/XP), with the G200 Marvel
the follow the instructions below to create a raw dump of the
bios.
<rtn> means hit the enter/return key
C:\>debug bios.bin <RTN>
-m c000:0 8000 cs:100 <RTN>
-r cx <RTN>
CX 0000 (this is displayed)
:8000 <RTN>
-w <RTN>
Writing 08000 bytes (this is displayed)
-q <RTN>
to verify it properly dumped the bios
C:\>debug bios.bin <RTN>
-d <RTN>
XXXX:0100 55 AA ?? ?? ?? ?? (you'll see the 55 AA)
-q <RTN>
You'll have a image called bios.bin with the pins complete
If someone does this for you then all you have to do after that
is with the bios update package
C:\>progbios -i bios.bin -k
This will flash the bios with the pins into your card then
all you have to do is change the serial number as shown
on this site
Oh yeah.. Warning.. this recover method will only
work with Millenium->G400.. It will wreck any other
matrox card after G400.. since their bios's are larger than 32K
It's also good to do this if you own one of these
products and keep the image in a safe place
incase you do scrap your bios in the future..
saves you the cost of RMA, and down time..
Comment