Marvel G200

[MB_Darren]

Am having trouble starting PC-VCR
After install it will work, but close it down and try start again I just get a black box.
Have tried uninstalling everything, even a total system rebuild, no luck.
Started experiencing this problem since upgrading computer.

Have PIII850 with Intel D815EPEA motherboard, 128MB RAM. Running the Marvel G200 AGP and a SiS6326 PCI card for secondary monitor.

Have loaded W9x_555 drivers with 9xvt1454 video tools, runnig DirectX8.0 (the only other change I can think of)

I am running my display at 16bit resolution, used to be able to run at 32bit.

I have copied the registry key and inpliment this, but even this isn't 100% working, getting sick of having to re-install and set everything up.

Any help whatsoever, or some pointers in the right direction to solve this little issue of mine appreciated.

Thanks

Darren.

[MB_Darren]

OK... now need some help from the experts..
I tried the following this morning.
- went to directx site, found there is a video update for directx8, applied, uninstalled all matrox drivers.. reinstalled, same problem.
- uninstalled all matrox drivers, installed from original supplied cd, same problem
- uninstalled directx8 and matrox drivers, installed directx7, matrox software, now cant get to work at all.

hmmm.. *ponder* a hammer maybe?

Could I have a hardware problem?

Madly waving my hand around as I drown..

Darren

[Kruzin]

You would have better luck with this in the Desktop Video forum, which is where the Marvel pros all hang out.

Relocated to Desktop Video forum...