Tweet
Lightwave5.6c/G200/Beta drivers (BAD)
I had a scary situation where I couldn't run both Lightwave Modeler and Layout at the same time.
The screen would just go black or the computer would completely shut down!
I figured that the only thing that was different from before was that I was using the beta drivers (I used the old .inf to install them on my G200 of course).
After un-installing them and overwriting PDeskcmd.exe and PDKernel.dll when I re-installed 5.3 (the best G200 drivers so far)everything went back to normal.
Just thought I'd share this with you people.
The screen would just go black or the computer would completely shut down!
I figured that the only thing that was different from before was that I was using the beta drivers (I used the old .inf to install them on my G200 of course).
After un-installing them and overwriting PDeskcmd.exe and PDKernel.dll when I re-installed 5.3 (the best G200 drivers so far)everything went back to normal.
Just thought I'd share this with you people.