If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I tried powerdesk 5.41 but videotools 1.51 are not working, when i select "line" for input, the system crash.
With the previous version of powerdesk everithink is working fine.
Ciao
Sebastiano
Win98: PD 5.41 is ok but VidTools 1.51 crashes when clicking on "Line" as source... STRANGE: On Win95 (B) VidTools 1.51 and PD 5.41 work perfectly... :-|
I use 5.41 with my MarvelG200 (I also have a G400 DH installed and allthough the comination of .30 and .41 does work i do not like it) and the only problem is that the Vidtools show no buttons...
------------------
this message was posted by Digital_Hell_Native
"Better to have people think you're a fool then to open your mouth and remove all doubt."
----------------------------
Samuel Clemens (Mark Twain) (1835-1910), American Writer
Thanks for the info guys ! Digital_Hell_Native I still haven't tried the new drivers but I once had this problem with no buttons on the remote ! I posted & was told you must install everything to default directory & all was well then.
Comment