Announcement

Collapse
No announcement yet.

Refresh Problem With AGP G100 Productiva

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Refresh Problem With AGP G100 Productiva

    Hi all,
    I'm having refresh problems.here's the deal:
    Whenever my monitor (a cybervision C70, which is not one of the listed monitors under specific monitor types (Vertical refresh 70.6 Hz, Horizontal 56.9 kHz)) goes into energy saving mode (i.e. goes blank, lite goes from green to orange), it has what appears to be static in place of my background picture, as well as on my windows task bar when I pop up my menus.

    I've tried setting the VESA monitor for 1024X760 (whatever it is) for 70-72 Hz, that doesn't do it.
    I also looked at the advanced monitor controls, Sync polarity is correct according to the monitor spec.'s (i.e. 1024X768 Hor Freq 56.6, Vert 70 Hz).
    I installed the new drivers for both monitor and the card (powerdesk 5.30, driver 4.1, whatever it is at now), and still have the same problem.

    Any suggestions would be more than welcome.
    Thanks!
    Cardinal
    jcalder@bgnet.bgsu.edu


    ------------------
    Computer Grad. Student
    Bowling Green State University
    and stuff....

    [This message has been edited by Cardinalae (edited 01 December 1999).]

    [This message has been edited by Cardinalae (edited 01 December 1999).]
    Computer Grad. Student
    Bowling Green State University
    and stuff....

  • #2
    Go to Matrox monitor selection, select VESA 1024x768 at 60 Hz, then go to customize settings and increase the refresh frequency to the highest good one for each mode.

    Comment

    Working...
    X