Tweet
vidtools 1.51 not working with PD5.3
I just tried PD5.3 with my Marvel G200. It did not work completely. Everything works except that the TV picture is distored to the upper left hand corner of the TV/VCR window. The rest of the window is just a green blank. I tried uninstall and re-install in several combinations and nothing worked. I had to revert back to PD5.25. I am very disappointed because I really like that I can use my Matrox Millenium PCI classic along with my Marvel G200 AGP. I hope Matrox fix it in the next Powerdesk release. That extra monitor/card combo has been gathering dust for almost a year now.
-
I just tried PD5.3 with my Marvel G200. It did not work completely. Everything works except that the TV picture is distored to the upper left hand corner of the TV/VCR window. The rest of the window is just a green blank. I tried uninstall and re-install in several combinations and nothing worked. I had to revert back to PD5.25. I am very disappointed because I really like that I can use my Matrox Millenium PCI classic along with my Marvel G200 AGP. I hope Matrox fix it in the next Powerdesk release. That extra monitor/card combo has been gathering dust for almost a year now.
-
My Marvel G400-TV had the same prob, but in different circumstances. Using DualHead Cloning to the TV, the TV-VCR screen goes "green blank" whenever at 1x or full screen (works only at .5x). On the monitor, it works fine in any window size, but not in the TV. But that was when I was using 5.25 drivers... I get the chance to borrow the TV again, I'll test.
------------------
** {RUN} spot {/RUN} **
Ryan
** {RUN} spot {/RUN} **
Ryan
Comment