Tweet
Sorry to interupt the G400 orgy, but have a few problems...
When first loaded the new 5.13 for my Mill G200, everything worked great-except the OpenGl screensavers (slow as frozen snot), and the card will not recover after the monitor has shut down (set to turn off after 20 min of inactivity...but no 'Standby Mode' is enabled..) Read something here about snagging the OpenGL32.dll from the Win98 disk, which seemed to cure the screensaver prob, but the card will still not recover after the monitor has shut down. Have to 'ctrl-alt-del' twice and reboot to get my screen back. Any clues? Haig? Is this a known prob?
------------------
Celery 464a, Tyan Tsanumi, Mill G200 Retail, Hitachi CM753 19"
When first loaded the new 5.13 for my Mill G200, everything worked great-except the OpenGl screensavers (slow as frozen snot), and the card will not recover after the monitor has shut down (set to turn off after 20 min of inactivity...but no 'Standby Mode' is enabled..) Read something here about snagging the OpenGL32.dll from the Win98 disk, which seemed to cure the screensaver prob, but the card will still not recover after the monitor has shut down. Have to 'ctrl-alt-del' twice and reboot to get my screen back. Any clues? Haig? Is this a known prob?
------------------
Celery 464a, Tyan Tsanumi, Mill G200 Retail, Hitachi CM753 19"